Customer reviews
Average Customer Review
7 Reviews

1 of 1 people found the following review helpful
5.0 out of 5 stars Correct parts and speedy delivery, January 12, 2019
By 
Judy
Verified Purchase(What's this?)
This review is from: Flextrol FTH30 Hydronic Expansion Tanks-for Hot Water Heaters, Carbon Steel Shell 3/4 Inch MIP Connection, SBR Synthetic Rubber, 60 PSI, 210 Degrees Fahrenheit, Gray Color, 4.8 Gallons (Tools & Home Improvement)
I purchased a" Flextrol" FTH30 Hydronic Expansion Tank 4.8 gallons, to replace a" Amtrol" 3.5 gallon expansion tank that was leaking. I also purchased a Taco HY Vent Cair valve. I was pleasantly surprised that the tank arrived in only 3 days, when I had expected arrival in over 1 week.
After cleaning the dirt and rust from around the old unit, I removed the old "Amtrol" tank that was rusted through with a little difficulty and installed the new "Flextrol" tank. I did not have any difficulty installing the new tank - it fit perfectly. I changed out the old Taco bleed valve and installed the new valve.
When The heating system was started, it took only 15-20 minutes for the system to equalize. Both of the new parts worked as expected.
Bottom line, great price, super fast delivery, direct fit, and a real happy customer.

Anthony J Lux

1 of 1 people found the following review helpful
3.0 out of 5 stars Just wanted to let you know that you call out ..., July 15, 2018
By 
Paula O
Verified Purchase(What's this?)
Just wanted to let you know that you call out 3/4 NPT thread and it's actually 1/2" NPT. The dimension for this type of thread is for pipe so it's measured on the inside not the outside of the thread. Anyway, you should either change your description or actually put a 3/4" NPT thread on the tank going forward.

5.0 out of 5 stars Works great. Inlet was smaller than expected but easily remedied ..., February 24, 2018
By 
AmazonCustomer sinceinception
Verified Purchase(What's this?)
This review is from: Flextrol FTH30 Hydronic Expansion Tanks-for Hot Water Heaters, Carbon Steel Shell 3/4 Inch MIP Connection, SBR Synthetic Rubber, 60 PSI, 210 Degrees Fahrenheit, Gray Color, 4.8 Gallons (Tools & Home Improvement)
Works great. Inlet was smaller than expected but easily remedied with a reduced. The seam around the middle is big and conflicted with my support bracket, but that's ok.

Share your thoughts with other customers:
 See all 7 customer reviews...